Adjusta-Watt E-Lite 1000w 400v Switchable Digital Ballast. Super HPS technology is taking the growing communitity by storm. That's because 400v ballasts deliver a greater light output than standard ballasts, while consuming the same amount of power!
The E-Lite ballast is designed to run ultra efficent 1000w DE (double ended) lamps to great effect. But, please not that the electrical connector on the E-Lite is designed for use with Sol Digital 1000w 400v reflectors.If you're looking for the latest lighting technology at an affordable price, then you'll be hard-pressed to find a better solution. Designed for high voltage 400V double ended lamps and reflectors. Delivers bigger and better yields than traditional 230v ballasts. Utilises technology that's used in the professional horticultural industry. Produces more PAR light per watt some of the highest of all HPS systems.
Comes with LED fault indicator feature. Over 30% more efficient than standard magnetic ballasts. Runs at a higher frequency than standard HPS.Adjustable output 400w/600w/1000w + 1100w "overdrive". SmartStart ignition control software and full circuit protection software. Thermostatic air-cooling with automatic frequency adjustment. Whisper quiet operation and compact design. RF sheilding with total harmonic distortion (THD). Dimensions: 27cm x 15cm x 6cm.
Standard mains power from your socket is rated at 230 volts; this ballast bumps up the voltage level to 400v and runs your lamps at a higher frequency, making it more efficient per watt of power. Super HPS delivers a superior spectral output, with excellent levels of photosynthetically active radiation (PAR).This results in faster growth rates, more resilient crops and bigger yields. This ballast is over 94% efficient at all output wattages, so it runs nice cool (below 25C under normal conditions) and it doesn't require an internal fan, ensuring that it also stays quiet. Special attention has been paid to making a product that produces almost no RF interference. It will not interfere with the signal reception of televisions, radios or wireless broadband. The E-Lite ballast features a soft-start system which does not produce a surge when it starts a lamp.
This means that several Adjusta-Watt ballasts can be started at the same time without a surge tripping out the mains. A host of other features are included in this ballast which can be found on sol digitals site. How to Use the Adjusta - Watt E-Lite Ballast.Although the Adjusta-Watt 600 Watt Switchable Digital Ballast runs fairly cool in use, it should still be located on a flat, firm, surface (not carpet) and in a well-ventilated location. It should never be covered and there should be no combustible items in the vicinity just in case. Connect the input lead of your reflector to the output lead of the ballast ensuring the cable is not pulled tight and does not come into contact with anything hot e. Ensure that your lamp is tightly fitted into the double ended lamp holder and that your reflector is at the correct height. Use the power-output switch to select the desired wattage and plug your ballast into the wall. The ballast will start-up and light the lamp. In the event of a fault, e. A faulty lamp or high ballast temperature, the ballast will go into protection mode. Once the problem has been rectified, the ballast will automatically reset and restart. The Adjusta - Watt also has hot-restrike protection: in the event of an interruption to the mains supply, the ballast will test the temperature of the lamps every 60 seconds and only re-strike them once they are cool enough to do so. Sol-Digital Super HPS DE Bulb (1000w / 400v).
Not content to just copy the competition, the research and development team at Sol-Digital have engineered their 400v / 1000w lamp to maintain it's spectrum as closely as possible when switching between different output levels (as is the case for other lamps in the Sol-Digital range). It's designed for use with the new Adjusta-Watt e-Lite 400v /1000w ballast, so you'll have all of the benefits of running three systems in one: a 400w, 600w & 1000w. However, because the lamp reduces spectral shifts and drops in efficiency to practically nothing, you'll also have none of the drawbacks.
For this reason, it also makes a great, cost-effective option for those looking to replace lamps in their existing 1000w pro systems (Gavita Pro 1000w and Dimlux 1000w). For use with the Adjusta-Watt e-Lite 400v / 1000w ballast and custom reflector.
Can also be used in other 400 volt systems like the Gavita Pro 1000w and Dimlux 1000w. Delivers yield increases of up to 20% over standard HPS lighting. Engineered to maintain its light output at varying output settings. Only needs replacing once a year (on average).Fast warm up and re-striking times. PAR value of 2050 umol/m2/s - as much useable plant light as the sun at midday! How the Super HPS Lamp Works. This lamp is designed for use with 400v ballasts and reflectors with special double ended (DE) lamp housings. 400v ballasts convert 230v mains electricity to 400 volts in order to run lamps at higher frequencies. This in turn delivers a more intense light with a broader spectrum, which results in faster growth rates, more resilient crops and bigger yields. The team at Sol-Digital have also engineered the lamp so that there are very few negative consequences when running it at different output settings. Inferior lamps don't always respond well to being turned up or down (particularly down), triggering a spectral shift and a reduction in efficiency. This Sol-Digital lamp will allow you to change lighting output levels without negative effects. Sol-Digital Stealth G-Spot Reflector (1000W / 400V). The G-Spot Reflector is designed specifically for use with the Adjusta-Watt e-Lite digital ballast and a 1000w double ended HPS lamp.
Its a very cost-effective alternative to the Gavita Hortistar Reflector. Designed to work with 1000w 400v HPS systems.Dimpled surface for even light distribution. Features eyebolts, making it easy to hang. RF shielded - no interference. How the G-Spot Reflector Works.
The G-Spot reflector will help you to get the best out of your Adjusta-Watt e-Lite ballast and Sol Digital 1000w double ended lamp. Its miro aluminium is highly reflective and its compact size ensures that the light from your lamp travels no further than it needs to, increasing intensity and enhancing yields. These reflectors are based around a design thats used in the professional horticultural industry, where tiny percentages count. How to Use the G-Spot Reflector.
The connector on the G-Spot reflector is designed for use with the Adjusta-Watt e-Lite digital ballast. It is not intended for use with ballasts that plug into reflectors via IEC or Weiland connectors. Set-up of a 400v system is the same as a typical 240w set-up (except the lamp fits in to the reflector slightly differently).
With the power turned off at the wall, install your lamp by fitting the wires into the slots either side of the reflector, then move the sliders down to seal the lamp in place. Use a clean cloth to handle the lamp to avoid leaving fingerprints, reducing its effectiveness. Note the image above, which shows you which way to install the lamp. The side with the little metal tag goes closest to the reflector cable.Plug the reflector cable into the ballast and plug the ballast into a wall socket. Youre probably going to want to run it on a timer. If this is the case, never plug it into the timer directly, but plug it into a timer via a contactor instead. Warning: When HID lamps are switched on they run extremely hot. As with all high-pressure sodium and metal halide bulbs it is necessary to avoid touching the lamp with anything such as fingers or plants as this may cause severe burns or fires.
In particular, avoid sprays or liquids coming into contact with the lamp as this may cause premature failure or even an explosion. Sol-Digital Stealth Euro DE Reflector (1000w / 400v). This reflector is the most simple and economical way of using the higher end 1000 watt 400 volt lamps on the market.
Sol-Digital products are known for their quality and reliablity so you can be confident that this simple design will deliver spot on results at an affordable price. For use with 1000 watt 400v lamps. Dimensions: 47cm x 35cm x 35cm. How the Sol-Digital Stealth Euro DE Works.This is no ordinary Euro Reflector. For a start, it's equipped to house the double ended lamp (K12x30s holder). It's officially certified as 95% reflective, with excellent diffusion levels, and is built to a very high standard, with a branded top plate and V-shaped hangers for attaching your rope ratchets or hangers. The lamp cord is also fully shielded, eliminating the chances of interference with radio or broadband equipment. How to Use this Reflector.
Holding your lamp with a clean cloth, insert it into the K12x30s bulb-holder at both ends, making sure that the lamp end with the additional tag (please see image above) is at the ballast end of the fitting and slide the mechanism towards the centre to lock in the lamp. Hang the reflector over the centre of the grow-space at an appropriate height using easy rolls or jack chain. Plug the lead into an appropriate 400v ballast and switch on.Warning - When HID lamps are switched on they run extremely hot. As with all high pressure sodium and metal halide bulbs it is necessary to avoid touching the lamp with anything such as fingers or plants as this may cause severe burns or fires. In particular avoid sprays or liquids coming into contact with the lamp as this may cause premature failure or even an explosion. Sol-Digital Stealth XXXL DE Reflector (1000w / 400v).
The Sol-Digital XXXL design is the must-have reflector if you're using a 1000 watt 400v lamp and you want total coverage for a larger garden. This Reflector is great for those working in a 1.5m x 1.5m grow space. For use with 1000w 400v lamps. Dimensions: Length 810mm, Width 705mm, Height 275mm. The Sol-Digital XXXL Reflector has an amazingly reflective dimpled surface along with reflective closed-ends to reflect as much light as possible straight downwards towards your plants.
The XXXL design ensures the optimum spead of light delivering an even coverage to each leaf on every plant in your grow space. Channel Islands: All postcodes containing GY and JE Isle of Man: All postcodes containing IM Scilly Isles: TR21-TR25 Scotland: All postcodes containing TR21-TR25 / AB37-AB56 Scottish Islands: All postcodes containing KW / HS1-HS9 / IV40-IV49 / IV51 / IV55-IV56 / KA27-KA28 / PA20-PA80 / PH4-PH50 / ZE1-ZE3 Scottish Highlands: All postcodes containing AB and IV / KW1-KW14 / PA20-PA38 / PA68 / PH80 / PH36-PH49 Northern Ireland: All postcodes containing BT Isle of Wight: PO30-PO41 Isle of Angelsey: LL Isle of Man: IM1-9. We use the best couriers available to us to ensure that your product is received on time and in great condition. Please ensure that someone is available to sign for the item as signatures are required.Your satisfaction is important to us and we always aim to provide the best products and service to all our customers. We simply require photos of said broken bulb upon which we will issue a replacement. Once replacement as has arrived, please send us an image of both bulbs together so we know the replacement bulb has arrived without any defects. Without photographic evidence, we cannot process your claim.
Customers must provide a day when someone will be home for collection of return. The item "Sol Digital Adjusta-Watt 1000w 400v E-Lite Dimmable Ballast Super HPS Light Kit" is in sale since Thursday, July 30, 2020. This item is in the category "Garden & Patio\Hydroponics & Seed Starting\Grow Light Kits". The seller is "warehousehydro" and is located in Grimsby. This item can be shipped worldwide.